Lobot
Feb01

Lobot

  CHARACTER DESCRIPTION Lobot was a Human male who served as the chief administrative aide to Baron Administrator Lando Calrissian on Cloud City over the planet Bespin.  His brain was connected to the city’s central computer which allowed him to communicate directly with the city’s computer network.  In this capacity, he served as the city’s first and only computer-liaison officer. Source Wookieepedia   REQUIRED ITEMS 1. Tunic a. Cream colored undershirt with wide billowy sleeves and cuff at the wrist and stand-up square collar. 2. Vest a. Gray in color (to match references) b. Has a Y-shaped bib section and two pocket flaps. Top stitching is visible near side boarder of bib and side and bottom of pocket flaps. c. Back of vest has parallel pleats at side that goes up and over the shoulder and ends at the pocket flaps near the arm pit. (Similar to shoulder tucks on the Jedi outer tunic, but extends all the way down the back of the vest.) d. Vest may be attached to the pants in a jumpsuit fashion if desired 3. Pants a. Full-length pants in the same color of the vest b. No pockets. 4. Belt a. The belt is black in color, featuring 2 layer construction.  The bottom layer should be of a thin leather like material that wraps around the costumer.  The top layer should be thicker and covered in a leather or leather like material. b. The belt has a wide portion that wraps from the costumer’s right hip to left hip.  The back of the belt is narrow, about 3 inches wide. c. The top layer of the belt contains a rectangular opening in the middle of the front portion to display the greeblies. This thick portion wraps from the costumer’s right hip to left hip. d. Greeblies include in the opening of the belt’s top layer include: 2 large silver discs 2 large black discs with a + configuration on the surface 2 Small black rectangles with silver borders 2 sets of 2 small silver rectangles A single silver rectangle  The bottom portion of a snap e. Connecting the vest and pants is a single small black belt loop piece centered on the back of the vest and pants.  The back of the belt should sit underneath this belt loop. 5. Headpiece a. Accurately shaped headpiece that is gray in color. b. There is a layer of light gray felt-like material over the top rim of the headpiece. c. LEDs can be either functional or not. d. The headpiece is symmetrical. Each of the two sides of the headpiece has the following: -Four red tinted...

Read More
Cloud City Wing Guard
Jan24

Cloud City Wing Guard

      CHARACTER DESCRIPTION The Bespin Wing Guard, informally known as the Bespin Security Guard, Cloud City Wing Guard, or Cloud Police, whose members sometimes were called Bespin cops, was the primary security force of Cloud City on Bespin. Source: Wookieepedia   REQUIRED ITEMS 1. Undershirt a. Shirt is a cream-colored turtleneck made of jersey material b. Only the turtleneck collar of the undershirt is exposed. 2. Jacket a. The jacket is blue in color and made of a matte material b. The jacket closes in the center using Velcro for the closure c. Trim on jacket is very thin almost flat gold piping. Piping goes around the neck down both sides of the jacket and around the back about 1″ inside the jacket edge. There is an additional looped design out of the same trim on the front lower corner of both sides of the jacket d. Jacket has a 3 inch high dart in the center of each side front at the bottom e. The sleeves of the jacket have red cuffs on the forearms that are pointed to a triangular shape on the outer side of the sleeve f. The top triangular points of the red cuffs are trimmed in black g. Jacket is collarless h. Jacket bottom is below the waistline and covers the waistline of the pants.   NOTE: The Jacket, Pants, and Helmet are a dark blue (not navy) in color and should match as closely as possible.  Since the Helmet is a suede like material it might be easier to purchase cream, white or ivory fabrics and then dye them so they all look the same. 3. Pants a. The pants are made of the same blue material as the jacket b. The pants are tucked into the boots c. Pants may close in front with standard fly stitching 4. Boots a. The boots are made of leather or leather-like material. No rubber boots allowed b. Boots come to just below the knee and are black leather. (No suede or vinyl or rubber boots) c. It is preferred that the boots have a visible full-length inside zipper with either a brass or gold colored regular zipper pull – however pull on boots will be permitted or smaller inside zippers. No laces or buckles allowed.   5. Helmet  a. Accurately shaped helmet based on the Ottoman Turkish Kabulak but worn backwards to create the very short visor effect. Material of hat should have a suede like appearance and match the jacket and pants in color. The helmet design is made from 2 belts. Each belt is made of a right and left...

Read More
Luke Skywalker (Bespin Fatigues)
Feb26

Luke Skywalker (Bespin Fatigues)

Luke Skywalker was a legendary war hero and Jedi who helped defeat the Galactic Empire in the Galactic Civil War and helped found the New Republic, as well as the New Jedi Order.

Read More
Luke Skywalker (Dagobah Training Fatigues)
Feb26

Luke Skywalker (Dagobah Training Fatigues)

Luke Skywalker was a legendary war hero and Jedi who helped defeat the Galactic Empire in the Galactic Civil War and helped found the New Republic, as well as the New Jedi Order.

Read More
Luke Skywalker (Snowspeeder / X-Wing)
Feb26

Luke Skywalker (Snowspeeder / X-Wing)

Luke Skywalker was a legendary war hero and Jedi who helped defeat the Galactic Empire in the Galactic Civil War and helped found the New Republic, as well as the New Jedi Order.

Read More
Luke Skywalker (Taun-Taun Hoth Gear)
Feb26

Luke Skywalker (Taun-Taun Hoth Gear)

Luke Skywalker was a legendary war hero and Jedi who helped defeat the Galactic Empire in the Galactic Civil War and helped found the New Republic, as well as the New Jedi Order.

Read More